MPN Series Press Side
(Feed Openings 8" X 12" )
Rotor: "Short Step" Rotor design,
segmented type, 6 scooped segments with 3 cutting knives = 18 knives.
Low rotor RPM 340, with a cutting circle 7" rotating end disc, 60lb
solid steel flywheel pulley. Knives made of High Carbon High
Chrome D3 Tool Steel.
Cutting Chamber: Steel bolted construction, Angle
mounted cutting chamber.
Bed Knives: 2 mounted 180 degrees opposed, knives made
of high carbon high chrome D3 tool steel.
Hopper: Safety interlocked. Clear view, hinge mounted no hand tools required
to open hopper, with safety interlock screen with 1/4" diameter
holes.
Motor: 5 HP - 60 HZ - 480V 1150RPM T.E.F.C.
Drive: "V" Belts (3 per set).
Electrical: Integral control panel with magnetic
starter, 110 volt controls and fused lockout disconnect switch and with
tamperproof safety interlock (OSHA and ANSI approved)
Capacity: *with 1/4" dia hole screen, up to 225 lbs./hr
Base: Caster mounted, two swivel and two straight,
"Urethane Type."
Bin: manual type regrind bin (Standard)
Floor Plan: 24" W x 27" D x 46" H (Feed tray height 40")
*Depends on size and shape of feedstock.
