|
|
|
CS Central Granulator CS-1636 (Feed Openings 16" x 36") Soundproofed Rotor: Slant open rotor design, 3 segments with 3 cutting knives = 9 knives. Low rotor RPM 650, with a cutting circle 16" rotating end disc, Knives made of High Carbon High Chrome D2 Tool Steel.Cutting Chamber: Bolted construction (water cooled chamber) improved tangential feed design. Bed Knives: 2 (3 section) mounted 180 degrees opposed, knives made of high carbon high chrome D2 tool steel. Hopper: pelican type, hinge mounted no hand tools required to open hopper. With tamperproof safety interlocks. Screen: Mounted in swing down cradle, with safety interlock screen with 3/8" diameter holes. Motor: 3 PH - 60 HZ 1720RPM T.E.F.C. Drive: "V" Belts (5 per set). Electrical: NEMA 12 panel with magnetic starter. Integral control panel with magnetic starter, 110 volt controls and fused lockout disconnect switch and with tamperproof safety interlock (OSHA and ANSI approved) Capacity: *with 3/8" dia hole screen, up to 1700 lbs./hr Discharge: 6" diameter tube for blower hookup. Base: Four leveling pads. Floor Plan: 61" x 72" D x 88" H (Feed tray height 65") Shipping Weight: Approximately 7000 lbs. *Depends on size and shape of parts.
|
Send mail to ricky@mpggranulator.com or mpgmike@dragonbbs.com with
questions or comments about info. Phone-800-440-9249
Fax-254-582-0402
|